The main is one tower a center bridge section and a left and right which is seen in the color picture. The add-on is also in color, but it has the tower the center section and a left bridge section. The bridge section stands about 10 3/4 inches tall 18 1/4 inches long and 4 1/2 inches width at the base of the tower.
You only need to buy a main section to have a complete bridge but if you want to make it longer, you just purchased the add-on. This is 3-D printed in white resin. It is an ABS like resin with tough resin mixed in to give it more durability superglue will be needed to assemble. The tower comes in two pieces of lower and upper half and then each bridge is a single section by itself so a total of five pieces for the main section 4 pieces for an add-on. Warping may occur and this is corrected with hot water, place it in hot water and it will retake its original shape. I use this method all the time with a lot of the gun barrels that I produce for miniature tanks. Just put it in a glass dish with some water put it in the microwave for a few minutes, and it will reform to its original shape. This does not come assembled or painted.
The main is one tower a center bridge section and a left and right which is seen in the color picture. The add-on is also in color, but it has the tower the center section and a left bridge section. The bridge section stands about 10 3/4 inches tall 18 1/4 inches long and 4 1/2 inches width at the base of the tower.
You only need to buy a main section to have a complete bridge but if you want to make it longer, you just purchased the add-on. This is 3-D printed in white resin. It is an ABS like resin with tough resin mixed in to give it more durability superglue will be needed to assemble. The tower comes in two pieces of lower and upper half and then each bridge is a single section by itself so a total of five pieces for the main section 4 pieces for an add-on. Warping may occur and this is corrected with hot water, place it in hot water and it will retake its original shape. I use this method all the time with a lot of the gun barrels that I produce for miniature tanks. Just put it in a glass dish with some water put it in the microwave for a few minutes, and it will reform to its original shape. This does not come assembled or painted.
